CPI OA0003-1

CPI OA0005-1

CPI OA0006-1

WM M1-540-P

Z QR-D-1

Z QR-M

Z QR-OTS-ML

FW 521

O2 Ohmeda Style Connector to 1/8" NPT Male

0.525" ID x .625"L Ferrules for MH4-XXA hose.

1/4" NPT male to Oxygen DISS male adaptor

Ferno Double O2 Bottle Holder, Base only

Ferno Double O2 Bottle Clamp

Oxygen Bottle Wrench for removing the regulator from the O2 bottle. Made from cast aluminum. Measures approximately 7.675" long, sold individually

Z QR-OTS-HL

WM FMA107

Emergency O2 Bypass Valve w/ manual shut-off, DISS termination on rear, 12VDC, Gray trim bezel

Digital O2 monitor display. Calibrated to 3000 psi. Measures 4" wide x 5.25" high.

AM Z-OX31200

AM Z-TH01MO

Conductive medical Oxygen Hose, 1/4" ID, Green. Priced Per Foot

AM Z-OX300200

CPI OA0008-1

Quick release "D" size O2 bracket, strap-less, stainless hardware, vertical mount

Rico suction pump, 12VDC. Capacity up to 2.1 cfm / 58.1 l/min, Vacuum to 22.2 in.Hg / -752 mbar

(Replaces Thomas part # 907CDC18)

Bracket consists of two separate ends (base and retainer) and two strap support brackets. Base and retainer ends can be spaced apart to accommodate “M”, “G”, and “H” cylinders. Four heavy-duty straps hold cylinder securely in place. Straps adjust to cylinder diameters of 6-3/4″ to 9-1/4″

Base and Retainer Dimensions: 14-3/8″L x 9″W x 8-5/8″H

Can be used alone or with QR-SA and QR-SAFD slide assemblies

Complies with SAE-J3043, AMD Standard 003 for oxygen tank retention systems, and GSA KKK specification when used as recommended. Complies with OSHA and insurance safety regulations.

Self Locking portable O2 bottle holder with quick-release. This unit is designed to hold the "D" size O2 bottle. (O2 bottle not included). Polished aluminum housing.

Other models are available for the "E" and Jumbo "D" cylinder as well.

Braided stainless High Pressure Oxygen Hose, 4 ft. length. 1/4" NPT Female on both ends.
Rated for 3000 psi.

DISS Hex Nut, Oxygen

1/4" Hose Barb Nipple for DISS Hex Nut, Oxygen

Anthony Products 610WM

WM M1-346-P

Amico O2 Pressure sensor/ Transducer, calibrated to 3000 psi. Comes with 72" lead. 1/8" NPT male thread

Amico high pressure oxygen gauge w/ wall plate, 1/4" NPT male termination on back side. This gauge can be connected directly to the Oxygen tank to read tank pressure.